How to start your classic car after it has been stored

On the Road 3 min read

When it’s time to take your collector car out of hibernation, a few key tasks can quickly get you back on the road. If you properly prepared your car for storage — and stored your classic car in an appropriate facility, getting it ready for spring should take just an afternoon and some patience.

Much of the work will be old hat to experienced collectors. Still, Ernie Morreau, shop foreman at RM Restorations in Blenheim, Ontario, advises a systematic approach to get your classic car ready to drive. His checklist for classic car inspection includes the tips below.

Tips for starting your classic car

Flush the fuel system and check the battery

“The first steps are to flush the fuel system and check the battery and charging system,” Morreau said. “If you didn’t remove the battery for storage, or didn’t use a trickle charger, there’s a good chance it might be dead.” Learn how to jump-start a car battery if it dies while in storage.

Check the oil in your classic car

Once you have cleaned the fuel system and fresh fuel added, Morreau recommends checking and changing the oil and other fluids, if you hadn’t done so before putting the car into storage. “Other fluids are pretty durable in the cold,” he said, so they should not need changing. Morreau advises owners to be mindful of the oil selection.

Flat-tappet camshafts used in cars made before the 1980s require oil with a zinc additive called ZDDP for lubrication; later engines with roller-tappet cams don’t need it (and zinc can contaminate catalytic converters). Oils formulated with ZDDP are available for older models, or the additive is available separately.

Check the cooling system for leaks

When checking your car for leaks, check your car’s coolant levels and cooling system and make sure all clamps are tight. If you mainly use your car for short drives, changing the coolant every two years should be sufficient, Morreau said. If you plan on longer drives, though, go ahead and change it. He cautions that corrosion can affect aluminum radiators and cylinder heads if a car sits unused for two to three years without a coolant change. Before reconnecting the fuel line, briefly crank the engine with the starter to circulate the oil. Once you connect the fuel and start the engine, allow it to reach full operating temperature and inspect for coolant leaks.

Run through that cycle a couple of times before driving. Even if the cooling system looked good at first, Morreau said, a water pump leak might show up, especially on a car from the 1930s. “The packing around the shaft dries up,” he said, referring to the sealing method on older pumps.

Start the car and check that it’s working properly

With the car running, check that the charging system is working. Before driving, check the brakes. A thorough check involves pulling each wheel and checking for hydraulic fluid leaks. There are some additional steps the prudent collector-car owner should take if extended drives are planned, according to Morreau. He strongly suggests having the car rebuilt beforehand if the car has a generator.

“I highly recommend installing an in-line electric fuel pump, too,” he says. “If you’re on a tour and the mechanical pump goes, you’re stuck.” Morreau advises connecting the pump to a toggle switch, with power drawn at the ignition switch so it will turn off with the car. “If the main pump dies, you just flip the switch,” he says. “We do this for cars from the 1930s to 1950s, and even some ’60s cars.”

Before you head out on the road, learn how you can protect your historic vehicle with classic car insurance from Progressive.

Was this article helpful?

4 min
6 min
3 min
5 min
3 min